1, before use should check the components, especially to check whether the rotary plow knife is installed and fixed bolts and universal joint lock pin is solid, found problems should be dealt with in time, confirm the safe before use.
2, before the tractor starts, the clutch handle of the rotary tiller should be shifted to the separation position.
3, to engage the power in the lifting state, until the rotary tiller reaches the predetermined speed, the unit can start, and the rotary tiller slowly lowered, so that the rotary tiller knife into the soil. It is forbidden to start directly when the rotary tilling knife is in the soil to prevent the rotary tilling knife and related parts from being damaged. It is forbidden to drop the rotary tiller rapidly, and it is forbidden to backslide and turn after the rotary tiller is put into the soil.
4, when the power is not cut off, the rotary tiller shall not be raised too high, the transmission Angle at both ends of the universal joint shall not exceed 30 degrees, and the engine speed should be appropriately reduced. When transferring the block or walking long distance, the power of the rotary tiller should be cut off and locked after rising to the position.
5, when the rotary tiller is running, it is strictly prohibited to approach the rotating parts, and there must be no one behind the rotary tiller, in case the blade is thrown out and hurts.
6, check the rotary tiller, must first cut off the power. When replacing rotating parts such as blades, the tractor must be turned off.
7, the speed of advance when farming, dry field to 2~3 km/h is appropriate, in the tilled or raked field to 5~7 km/h is appropriate, in the paddy field farming can be properly faster. Remember, the speed should not be too high to avoid the overload of the tractor and damage to the power output shaft.
8, when the rotary tiller works, the tractor wheels should walk on the uncultivated land, so as not to compact the cultivated land, so it is necessary to adjust the tractor wheel pitch so that the wheels are located in the working range of the rotary tiller. When working, pay attention to the walking mode to prevent the other wheel of the tractor from compacting the cultivated land.
9, in the operation, such as the knife shaft too much tangled grass should be stopped in time to clean, so as not to increase the load of the machine.
10, rotary tillage, tractor and suspension parts are not allowed to take people, to prevent accidentally by the rotary tiller injury.
11. When using the rotary tiller group of the walking tractor, the rotary tiller can be hung only when the auxiliary gear shift lever is placed in the "slow" position. If you need to reverse during work, you must put the auxiliary gear shift lever in neutral to hang the reverse gear. As far as possible, the steering clutch is not used in rotary tillage, and the direction is corrected by pushing and pulling handrails. When turning in the ground, you should first reduce the throttle, lift the armrest, and then pinch the steering clutch, do not turn dead, to prevent damage to parts.
